EZ-REMOTE® TEST PLATFORM
Contact Electrodata at 1-800-441-6336
EZ -REMOTE® FRONT PANEL VIEW
EZ -REMOTE® REAR PANEL VIEW
EZ -REMOTE® COMPUTER ENHANCED TESTING
SCREEN
THE REMOTE TESTING SOLUTION FOR DS1, DS3, STS-1 AND SONET OC3/OC12
TRANSMISSION
The EZ-REMOTE test platform shelf incorporates the same features, options
and capabilities as the combination of the EZ-TESTER ST (STS-1 SONET test
set) and the LIGHT-MATE I (LM-1) OC3/OC12 lid. The EZ-REMOTE can
be connected to a DACS, a SONET add/drop multiplexer or another test access
point for remote testing capabilities. Optical testing is performed using
a laser signal source plus an optical receiver for monitoring customer
or test signals. FC type RX and TX optical connectors are provided for
SONET OC3/OC12 test access. STS-1, DS3, DS1 and DS0 signals can be dropped
and inserted from an OC12 or OC3 signal at the optical test access point.
BNC type RX, TX and EXT connectors are provided for STS-1/DS3 test access.
DS1 and DS0 signals can be dropped and inserted for testing from a STS-1
or DS3 level signal via the STS-1/DS3 test access point. Bantam RX, TX
and REF jacks are provided for DS1 test access. DS0 signals can be dropped
and inserted for testing from a DS1 level signal via the DS1 test access
point.
SINGLE OPTICAL WAVELENGTH
The EZ-REMOTE operates at 1310nm or (optional) 1550nm.
POWER MEASUREMENT
Receive power measurement is standard.
PAYLOAD BERT
Standard test patterns provide BERT testing on the concatenated payload
across the entire optical bandwidth or STS-x sub-sets.
DESIGN FEATURES
-
Rugged metal case approximate dimensions (17"W X 15 1/4"L X 3 1/4"D).
-
Mounts on a standard 19" EIA rack or a 23" rack with adapters.
-
Controlled through a LAN 10Base-T/100Base-T Ethernet connection.
-
Windows base Graphics User Interface for ease of use.
-
Auto configuration feature determines line characteristics and reduces
setup time.
-
Includes stored test patterns and programmable byte vital to SONET testing.
-
Enables STS-1, DS3, DS1 and DS0 channel access from any of the higher order
transport.
ATM OPTION
-
Single-ended and full-duplex testing across the network.
-
Support for both UNI and NNI configurations.
-
Quality of Service (Qos), BERT, and OAM measurmennts.
-
Measure cell delay and variation.
-
Cell count and rate, including bandwidth and congestion.
-
Scan network for all active VCC traffic.
-
Detect and count lost and mis-inserted cells.
-
Pseudo-random and user patterns in cell payload.
-
Generates Foreground cell stream at selected rate.
-
Generates Background cell stream or cells.
Copyright ©2007 Electrodata, Inc. Windows® is a registered
trademark of Microsoft Corporation.